产品描述

Product Data 产品资料: Tempilink G-FRC-903
EO Gas Sterilization Indicating Ink 环氧⼄乙烷灭菌指示油墨
This easy to apply, easy to clean up waterborne ink will produce a flexographic print, capable of
functioning as a process indicator for EO gas sterilization process.
本水性油墨容易印刷或清洁，适用于柔版印刷，作为环氧⼄乙烷气灭菌的程序指示器

PERFORMANCE CONDITIONS: Requires EO gas, Moisture, and Temperature. Increasing amounts of
each, decrease time required for signal development. At 600 mg/l EO gas and a temperature of 120°F
(49°C), and relative humidity in the range of 60%-85%, color change will develop.
颜色转变条件: 环氧⼄乙烷气，湿气，温度，增加以上变色条件，可缩短变色时间。于环氧⼄乙烷气浓度
600mg/l，120°F (49°C) 及相对湿度60%-85%，颜色开始转变。
*We recommend not adding more than 5 % thinner. However, this amount can be exceeded as long as you
check that you get a good initial (print) and good final (signal) color.
*建议稀释不超过10%，但也可以在经过测试效果满意的情况下，按需要作适度增加。
Disclaimer: All information on this data sheet is based on general experience and for guideline purpose only.
Tempil makes no representation or warranties of any kind concerning this data

价格条款︰ 具体价格，以当日报价单为准

付款方式︰ 全款到账即发货

产品规格︰ INDICATING TRANSFORMATION 颜色转变
INITIAL COLOR 初始颜色
SIGNALLED COLOR 讯号颜色
Red 红色
Brown 棕色
PHYSICAL PROPERTIES 物理特性
SPECIFIC GRAVITY 比重 1.06 (8.9 lbs/gallon 英镑/加仑)
VISCOSITY (Brookfield-RVT) 黏度 700 cps (#3 spindle 转子 @ 20 RPM 转/分钟)
VOC’s (ASTM D 2369-87) 挥发有机化合物 None 无
WEIGHT % SOLIDS 固体百份比% (重量) 39
GUIDELINES FOR USE 使用指引
ANILOX 网纹辊 95 – 100 lines/inch 线/英寸 (38-40 lines/cm 线/厘米)
APPLICATION METHOD 印刷方法 Flexographic 柔版
COVERAGE (Approximate) 覆盖面积 (大约) 1100 ft²/gal 平方英尺/加仑 (27 m²/l 平方米/公升)
DRYING TEMPERATURE 干燥温度 110°F - 125°F (43°C-52°C)
PRESS SPEED 印刷速度 200 - 400 ft/min 英尺/分钟 (60-120 m/min 米/分钟)
SUBSTRATE 印刷基材 Paper Kraft 牛皮纸 / Tyvek 特卫强
MIXING INSTRUCTIONS 混合方法 Proper homogeneous mixing of active ingredient from iink is
essential for good color change 完全均匀匀混合
RECOMMENDED THINNER 建议稀释剂 Water* 水 (CAS # 7732-18-5)
SHELF LIFE 存放期限 6 months from the date of shipment 出厂后6个月
STORAGE 存放方法 Store inks in their original container in dry location at a
temperature between 60°F/15°C and 80°F/27°C.
存放于阴凉干燥环境，温度保持在 60°F/15°C 至 80°F/27°C

产品优点︰ 使用方便，变色稳定

主要市场︰ 医药包装，密封袋子

最小订量︰ 1加仑

交货日期︰ 现货