產品描述

Product Data 產品資料: Tempilink G-FRC-903
EO Gas Sterilization Indicating Ink 環氧⼄乙烷滅菌指示油墨
This easy to apply, easy to clean up waterborne ink will produce a flexographic print, capable of
functioning as a process indicator for EO gas sterilization process.
本水性油墨容易印刷或清潔，適用於柔版印刷，作為環氧⼄乙烷氣滅菌的程序指示器

PERFORMANCE CONDITIONS: Requires EO gas, Moisture, and Temperature. Increasing amounts of
each, decrease time required for signal development. At 600 mg/l EO gas and a temperature of 120°F
(49°C), and relative humidity in the range of 60%-85%, color change will develop.
顏色轉變條件: 環氧⼄乙烷氣，濕氣，溫度，增加以上變色條件，可縮短變色時間。于環氧⼄乙烷氣濃度
600mg/l，120°F (49°C) 及相對濕度60%-85%，顏色開始轉變。
*We recommend not adding more than 5 % thinner. However, this amount can be exceeded as long as you
check that you get a good initial (print) and good final (signal) color.
*建議稀釋不超過10%，但也可以在經過測試效果滿意的情況下，按需要作適度增加。
Disclaimer: All information on this data sheet is based on general experience and for guideline purpose only.
Tempil makes no representation or warranties of any kind concerning this data

價格條款:︰ 具體價格，以當日報價單為準

付款方式︰ 全款到賬即發貨

產品規格︰ INDICATING TRANSFORMATION 顏色轉變
INITIAL COLOR 初始顏色
SIGNALLED COLOR 訊號顏色
Red 紅色
Brown 棕色
PHYSICAL PROPERTIES 物理特性
SPECIFIC GRAVITY 比重 1.06 (8.9 lbs/gallon 英鎊/加侖)
VISCOSITY (Brookfield-RVT) 黏度 700 cps (#3 spindle 轉子 @ 20 RPM 轉/分鐘)
VOC’s (ASTM D 2369-87) 揮發有機化合物 None 無
WEIGHT % SOLIDS 固體百份比% (重量) 39
GUIDELINES FOR USE 使用指引
ANILOX 網紋輥 95 – 100 lines/inch 線/英吋 (38-40 lines/cm 線/釐米)
APPLICATION METHOD 印刷方法 Flexographic 柔版
COVERAGE (Approximate) 覆蓋面積 (大約) 1100 ft²/gal 平方英呎/加侖 (27 m²/l 平方米/公升)
DRYING TEMPERATURE 乾燥溫度 110°F - 125°F (43°C-52°C)
PRESS SPEED 印刷速度 200 - 400 ft/min 英呎/分鐘 (60-120 m/min 米/分鐘)
SUBSTRATE 印刷基材 Paper Kraft 牛皮紙 / Tyvek 特衛強
MIXING INSTRUCTIONS 混合方法 Proper homogeneous mixing of active ingredient from iink is
essential for good color change 完全均勻勻混合
RECOMMENDED THINNER 建議稀釋劑 Water* 水 (CAS # 7732-18-5)
SHELF LIFE 存放期限 6 months from the date of shipment 出廠后6個月
STORAGE 存放方法 Store inks in their original container in dry location at a
temperature between 60°F/15°C and 80°F/27°C.
存放于陰涼乾燥環境，溫度保持在 60°F/15°C 至 80°F/27°C

產品優點︰ 使用方便，變色穩定

主要市場︰ 醫藥包裝，密封袋子

最小訂量︰ 1加侖

交貨日期︰ 現貨

產品圖片