Product Data 产品资料: Tempilink G-FRC-903
EO Gas Sterilization Indicating Ink 环氧⼄乙烷灭菌指示油墨
This easy to apply, easy to clean up waterborne ink will produce a flexographic print, capable of
functioning as a process indicator for EO gas sterilization process.
本水性油墨容易印刷或清洁，适用于柔版印刷，作为环氧⼄乙烷气灭菌的程序指示器
PERFORMANCE CONDITIONS: Requires EO gas, Moisture, and Temperature. Increasing amounts of
each, decrease time required for signal development. At 600 mg/l EO gas and a temperature of 120°F
(49°C), and relative humidity in the range of 60%-85%, color change will develop.
颜色转变条件: 环氧⼄乙烷气，湿气，温度，增加以上变色条件，可缩短变色时间。于环氧⼄乙烷气浓度
600mg/l，120°F (49°C) 及相对湿度60%-85%，颜色开始转变。
*We recommend not adding more than 5 % thinner. However, this amount can be exceeded as long as you
check that you get a good initial (print) and good final (signal) color.
*建议稀释不超过10%，但也可以在经过测试效果满意的情况下，按需要作适度增加。
Disclaimer: All information on this data sheet is based on general experience and for guideline purpose only.
Tempil makes no representation or warranties of any kind concerning this data
